Villard cascade on mains voltage

It is operated with 50 Hz. Mains voltage so. Prior to the test with 24V.

That I need 100µ up testing jobs I doubt Very much heavily. The Threadersteller 15nF had used even in the other thread (Villard cascade (high voltage cascade)) and it ran...
I want to not know ...und for bucket I got at 1000V and 470µ...

anywhere else that must chop sit... If the other has also gefunzt...

and the circuit looks the same. Is the same as listed in the annex.


With a 22nF capacitor you have an internal resistance of 150Kohm that makes per level after 3 levels already 450Kohm if your instrument has an impedance of 1Mohm, you measure then it only 2/3 the voltage

OK, apart from them, why always remains the same voltage because? And if something would change, but it's just my meter, why can I do then no funken-(strecke) at 230V?

Test way back touched at 24V input and more than A little bit krisseln Institute also does not...

Was measured with a Power System Studies commercially available fluke 192 and once with a fluke of Scopometers 196C...

And how can getting rid of the problem?
I'll buy me an extra gauge never just for such a stupid circuit...